We only had this problem with our ICP/MS units, I have not seen it so far with the GC/MS units. If it gives the error "The instrument is already in use by another chemstation" then you must go into the advanced tab on the networking screen and move the card with the instrument attached to the top of the list. The other card in the computer is connected to the lab server for uploads to LIMS. The GC and MS are connected to a hub, which is connected to one of the network cards in the computer with MSDChemstation. I was told, to connect the instrument to the network through its hub/switch. I had trouble installing chemstation until I took one card out. Not usually a problem on modern computers but back when we were running 386/486 computers it would take longer to quantify the data from a run than it did to cool the 5890 down from 230C to 35C.īigbear wrote: James how do you get the computer to recognize chemstation? Our IT section provided two computers for our E0202 systems.
If it is not dedicated and there is a lot of traffic on the network it could cause slower communications.Īre you running the data analysis as part of the run, or quantifying it by hand after? If you have Data Analysis checked on the start run screen then it will perform the data analysis portion of the method before it steps to the next sample.
We always run two cards in the computer, one dedicated to the instrument and another to communicate with the server for uploads to the LIMS. Is the network connection dedicated to the instrument or is it passing through the entire network of the building? We have one NIC card installed, however the data is saved locally on the C:// drive. SMinero wrote: Has anyone experienced ChemStation (G1701EA, E.02.02 SP2) running extremely slow between sample injections? For example, on a five minute run, it may take an additional 3-4 minutes for chemstation to finish acquiring data and perform the next sample injection.
0 kommentar(er)
